Filter
Top Products
D:\DVR project\Instruction
manual\DTP\2689634111\GB13ADD-CEK.fm
master page=left
SVR-S500
2-689-634-11(1)
48
There is no sound.
, Re-connect all connections securely.
, The connecting cord is damaged.
, The input source setting on the amplifier or the
connection to the amplifier is incorrect.
, The recorder is in reverse play, fast-forward,
slow motion, or pause mode.
, A scrambled channel is selected.
, The volume MUTING button has been pressed.
The sound volume is low.
, Check and adjust the audio output level in
“Video and Audio Settings (Options)” setup
(page 43).
Sound break up
, Signal strength low.
, Check aerial installation.
The recorder does not play.
, Moisture has condensed inside the recorder.
Leave the recorder turned on for about half an
hour until the moisture evaporates.
The language for the sound track cannot be
changed.
, Not all broadcasts carry multilingual language
tracks. In that case you can only listen in the
default language.
TV Pause does not work.
, Two simultaneous programmes are currently
recording to the HDD or the HDD is full.
The programme position cannot be changed
from the programme position you are
recording.
, Set the TV’s input source to “TV.”
, When two simultaneous programmes are
currently recording to the HDD, you can only
watch one of these two channels or play a title
from the Title List.
Nothing was recorded even though you set the
timer setting correctly.
, There was a power failure during recording.
, Disconnect the mains lead from the mains for at
least 10 seconds, and connect it again.
, There is not enough disk space for the recording.
, A scrambled or teletext channel was selected.
, Parental Lock has been activated (page 40).
Recording does not stop after you press x.
,
You may have to press
x
REC STOP.
Timer recording is not complete or did not start
from the beginning.
, There was a power failure during recording. If
the power recovers when there is a timer
recording, the recorder resumes recording.
, Disk space was not enough.
, The broadcast schedule changed.
One Touch Recording does not start after you
press z REC
, One Touch Recording is not possible if no TV
Guide information is available for the particular
programme. In this case you can record the
programme by setting the timer manually
(page 26).
, There is not enough disk space for the recording.
, The programme overlaps with two other timer
settings.
The TIMER REC indicator is flashing.
, The HDD does not have enough space.
The clock does not appear in the front panel
display.
, The front panel lighting has been set to “Off”
(page 44).
The remote does not function.
, Batteries are weak.
, The remote is too far from the recorder.
, The remote’s manufacturer code returned to the
default setting when you replaced the batteries.
Reset the code (page 11).
Sound
Playback
Recording/Timer recording/
Editing
Display
Remote control