Filter
Top Products
24
Recording
Setting the Mode at the End of
the Tape
You can set the mode of the tape operation when the
tape comes to the end during recording in the
GENERAL SET menu.
When the REPEAT REC switch is set to OFF
1 Turn on the power of the equipment to be used.
2 Press MENU and MENU
V
until “4” of the MAIN
MENU flashes on the monitor screen.
3 Press MENU
B
.
The GENERAL SET menu appears.
4
Press MENU V to move the flashing to the setting
of
TAPE END MODE
and set to REW or STOP by
pressing MENU + or –
.
REW: when the tape comes to the end, the VCR
rewinds the tape automatically and enters stop
mode at the beginning of the tape.
STOP: when the tape comes to the end, the VCR
enters stop mode at once.
5 Press SEARCH to return to the normal display.
Note
Even if TAPE END MODE is set to STOP, the VCR
operates according to the settings of ALARM DATA REC
and/or TAPE USED COUNT if those settings are set to ON.
Checking the Used Time
1 Turn on the power of the equipment to be used.
2 Press MENU and MENU
V
until “7” of the MAIN
MENU flashes on the monitor screen.
3 Press MENU
B
.
The POWER FAILURE/DEW/USED HOUR
menu appears.
VIDEO HEAD: the amount of time the video head
has been used.
POWER ON: the amount of time the power has
been on.
4 Press SEARCH to return to the normal display.
1 2-4 5
USED HOUR
VIDEO HEAD
POWER ON
H
H
ON
OFF
RETURN : MENU
<
NEXT PUSH
>
015
:
0010 12 11
:
0012–20
00000
00000
12
GENERAL SET
TAPE
TAPE IN
TAPE END
MODE
MODE
TAPE USED COUNT
CLOCK ADJUST
APC
THREAD CHECK
T
/
D SEARCH
T–160
STOP
REW
OFF
01:00
ON
OFF
CONVENTION
19200
SELECT : DATA SET :
+
/
–
RETURN : MENU
<
NEXT PUSH
>
BAUD RATE