Filter
Top Products
TL H.264 DVR User’s Manual
74
5.6.7.5 Detection Config
If motion detection function is enabled, it is required to define the motion
detection parameters such as detection area and sensitivity settings. Select a
channel for setting the parameters, move the cursor to <Detection Config>
and press ENTER. The Detection Configuration menu displays as follows.
Detection Config
1. Detected Area Setup
2. Sensitivity
3. Block Threshold
88%
4
Detected Area Setup
After selected this item, the detected area is displayed as follows. The
detection area consists of 192 (16×12) detection grids.
Use the Direction keys to move the cursor and press ENTER to select or
de-select a grid. Press MODE to select all of the grids for detection; press
MODE again to de-select all of the grids.
Sensitivity
This item is used to set the sensitivity of detection grids for the camera. A
greater value indicates more sensitive motion detection. A motion alarm will
be triggered once the amount of motion detected exceeds the Threshold
value.
Move the cursor to <Sensitivity> and press ENTER, and then use UP/ DOWN
keys to adjust the value. The value is increased by 4% increment.
Block Threshold
<Block Threshold> indicates the motion alarm triggered level; select from <1>
to <16>. Selecting <1> means the DVR will trigger the alarm when one grid is
detected; and selecting <16> means the DVR will trigger the alarm when 16
grids are detected. Move the cursor to <Block Threshold> and press ENTER,
and then use UP / DOWN keys to adjust the value.