Filter
Top Products
TL H.264 DVR User’s Manual
75
5.6.7.6 Alarm In
This item allows users to enable/ disable alarm input detection. According to
users’ application, select <N/O> (Normal Open) or <N/C> (Normal Close) to
enable the alarm input detection, or select <OFF> to disable the detection.
If <N/C> is selected without installing any device, an alarm will be triggered
and the Event Icon will always display on the monitor until the selection is
changed to <N/O> or <OFF>, or when a device is installed.
5.6.7.7 Alarm Out
This item allows users to enable/ disable the alarm output on the selected
channel to activate the relay. The signal can be a light or siren to caution an
alarm event. Select <ON> to enable the alarm output, or <OFF> to disable.
5.7 Database Setup
The menu displays information of internal and external HDDs. In the main
menu, select <Database Setup> and press ENTER. The following menu is
displayed.
Database Setup
1. Total Size
2. Free Size
3. Avail. Rec Time
4. Internal Disks
xxx GB
(Circular)
(Circular)
NOTE: If the detection of HDDs fails, the message “HDD fail” will be
displayed.
5.7.1 Total / Free Size of HDD
Total Size shows the total storage capacity of HDDs that have been added to
the database. Free Size indicates free storage space available for recording
in the database, or “Circular” will be shown if the DVR is set to record in
circular mode. Both of them are “read only”.
5.7.2 Available Recording Time
The Avail Rec. Time indicates the available time duration for recording. If the
DVR is set to record in circular mode, the item will show “Circular”. The
information is “read only”.