Filter
Top Products
Chapter 2 Quick Start
19
2.3 Device Setting
SRC-7000 will automatically get through the setup mode when you
operate the SRC-7000 for the first time.
1. Select the targeted device you wish to set up. Please tap the target
device key in the Main Menu to enter “Setup device” menu. (ex. “TV”
device)
1. 2. 3.
* Pre-code: load pre-programmed IR code from the factory
default (no guarantee being able to control all brand
devices).
2. Press the
or buttons to choose “Yes” item and press
button for entering the operation mode.
3.
Choose the first letter of targeted device brand (ex. “S” on
behalf of Sony, Samsung…etc), and point the SRC-7000 at
the targeted device. After selecting “Brand” item, please
turn on your target device.
Tap soft button to start auto searching. When you see
the targeted device has been turned off, tap or press any
button immediately to stop auto searching. Then press
to test the power key. If it can’t work, please go through
step as below.
Tap or gently to figure out the correct remote
code (Code number as shown on the top middle position of
the LCD.) until the targeted device has been turned on
again. Press the power key or the hard key to test and to
confirm the codes.