Filter
Top Products
73
Problem Solution
You see an “error” display
during operation.
• The key that you pressed has not been taught or input the IR
code.
• Teach the key via learning procedure. (P.37)
IR Learning is not
successful.
• Do not use the learn function near an incandescent lamp.
• Memory capacity is full (64 keys for each device.).
• Replace new batteries in the SRC-7000 and the remote you are
trying to configure.
• Keep the learning distance between the remote control and
SRC-7000’s learning eye about 2~4 inches apart (5-10cm).
• The learning process has no errors, but you still can’t control
your target devices:
- The battery in the target remote doesn’t have enough
power.
- Original remote might not be compatible with learning
procedure. Repeat the learning procedure again.
- If you still can’t solve the problem, contact SUNWAVE for
help.
Macro does not work.
• Be sure to aim the SRC-7000 at the devices while the Macro
commands are being sent.
• Macro was not properly set up. Repeat macro set-up
procedure. (P.42)
A key of your existing
remote performs two or
more functions
• Some remotes issue multiple commands when a key is held
down. Please be sure to teach different keys of SRC-7000 for
these different commands.
• Each key of SRC-7000 can learn 6 commands in a Cycle key.
(P.40)
The LCD screen turns off.
• The SRC-7000 is preset automatically to switch the LCD off
after 1 minute by default if left unused. You can also setup the
idle time to turns off the LCD. (P.54)
• You can turn on the SRC-7000 again as followed:
- Tap the touch screen
- Pick up the SRC-7000
- Press the hard key
The touch panel isn’t
sensitivity
• Please re-calibrate your touch panel (P.17)