Filter
Top Products
Chapter 3 How to Set Up Your SRC-7000
23
6. 7.
6. Please decide the “Device Category” for your device by pressing
the
or buttons. Press the to confirm and enter
next step.
7. Finally, please decide how you will load the IR remote codes for
the device. There are three choices for you: “Pre-code”,
“Learning” and “Done”. For more detail please refer to the
following sections to get further understanding.
3.1.2 Load the Codes for the Newly-added Device
When adding a new device, you will be asked if you will load the
codes for your device. There are two ways to load IR remote codes
for your newly-added device: “
Pre-code” & “ Learning”.
Please choose one of these two ways to load the codes. If you
don’t want to load any codes for the device, just select “Done” to
finish the setting process.
A. Pre-code
SRC-7000 is equipped with a huge pre-programmed code
database. With this function you are able to load the remote codes
for your device easily. It also enables you to control the device even
if you lose your original remote.
When you have successfully added a new device, and want to use
the “Pre-code” to load the codes, please choose this item.