Filter
Top Products
SRC-7000 User’s Manual
24
1. 2. 3.
1. Decide the “Device Category” for your device by pressing the
or buttons. Press the to confirm and enter to
next step.
2. Decide how you will load the IR remote codes for the device.
Select “Pre-code” press
to confirm.
3.
Choose the first letter of targeted device brand (ex. “S” on
behalf of Sony, Samsung…etc), and point the SRC-7000 at the
targeted device. After selecting “Brand” item, please turn on
your target device.
Tap soft button to start auto searching. When you see the
targeted device has been turned off, tap or press any button
immediately to stop auto searching. Then press
to test the
power key. If it can’t work, please go through
step as below.
Tap or gently to figure out the correct remote code
(Code number as shown on the top middle position of the LCD.)
until the targeted device has been turned on again. Press the
power key or the hard key to test and to confirm the codes.
If the codes are not correct please repeat
steps and select
“All”. Repeat the
~ again to find the proper code for your
target device.
4. If they work, it means that you have found the correct remote
codes. Please press the
button to confirm your decision.
When you are in step 3 you will see an icon located on
the top-right of LCD. It is “Key Pad Entry” function. (Please
refer to P.35 for more detail.)