Filter
Top Products
D14635.02—MARCH 2010
14
TANDBERG Codec C90 and Profiles using C90
Administrator guide
Contents Introduction Advanced configuration Password protection About monitors Audio matters Appendices Contact us
www.tandberg.com
Audio Output Line [1..6] Level
Defines the output level of the selected Audio Output Line connector in steps of 1dB from -24dB to 0dB.
See the Audio Level tables in the Physical Interfaces Guide for the codec for a complete overview of the
menu values represented indB.
Valuespace: <-24..0>
Range: -24 to 0dB
Example: Audio Output Line 1 Level: -10
Audio Output Line [1..6] Mode
Determines whether or not the selected Audio Line output connector is enabled.
Valuespace: <On/Off>
On: Set to On to enable the Audio Line output.
Off: Set to Off to disable the Audio Line output.
Example: Audio Output Line 1 Mode: On
Audio Output Line [1, 3] Type
Determines if the selected Audio Line output connector is an analog or digital type output.
Valuespace: <Auto/SPDIF>
Auto: If a TANDBERG Digital NAM is detected then SPDIF mode will be selected, otherwise analog
mode will be selected.
SPDIF: Set to SPDIF when you want the Audio Line 1 or 3 output to be in digital mode.
Example: Audio Output Line 1 Type: Auto
Audio Output Line [2, 4, 5, 6] Type
Line output 2, 4, 5, 6 are dedicated analog outputs, hence type can be set to analog only.
Valuespace: <Analog>
Can be set to analog only.
Example: Audio Output Line 2 Type: Analog
Audio SoundsAndAlerts KeyTones Mode
The system can produce a sound every time a key on the remote control is pressed.
Valuespace: <On/Off>
On: There will be a sound indicator when pressing keys on the remote control.
Off: The remote control Key Tones is switched off.
Example: Audio SoundsAndAlerts KeyTones Mode: Off
Audio SoundsAndAlerts RingTone
Selects the ring tone for incoming calls.
Valuespace: <Marbles/IceCrystals/Polaris/Alert/Discrete/Fantasy/Jazz/Nordic/Echo/Rhythmic>
Range: Select a tone from the list of ring tones.
Example: Audio SoundsAndAlerts RingTone: Jazz
Audio SoundsAndAlerts RingVolume
Sets the ring tone volume[0-100] for an incoming call in steps of 0.5dB from -34.5dB to 15dB.
Valuespace: <0..100>
Range: Select a value from 0 to 100. Volume 0 = Off.
Example: Audio SoundsAndAlerts RingVolume: 50
Audio Volume
Sets the volume level [0-100] on the loudspeaker output in steps of 0.5dB from -34.5dB to 15dB.
Valuespace: <0..100>
Range: Select a value from 0 to 100. Volume 0 = Off.
Example: Audio Volume: 70
The Audio settings, cont... The Audio settings, cont...
Contact us
Contents
Introduction
Advanced configuration
Password protection
About monitors
Audio matters
Appendices
Advanced config.