Filter
Top Products
D14635.02—MARCH 2010
29
TANDBERG Codec C90 and Profiles using C90
Administrator guide
Contents Introduction Advanced configuration Password protection About monitors Audio matters Appendices Contact us
www.tandberg.com
SystemUnit CallLogging Mode
Enables/disables logging of calls received or placed by the system. The call logs may then be viewed via
the GUI or using the xHistory command.
Valuespace: <On/Off>
On: Enable logging.
Off: Disable logging.
Example: SystemUnit CallLogging Mode: On
SystemUnit IrSensor Mode
The System Unit IR Sensor setting determines whether the infrared receiver on the codec should be
enabled or not. The IR sensor LED is located in the front of the codec and flickers when an ir signal is
received from the remote control.
Valuespace: <On/Off/Auto>
On: Set to On to enable the IR sensor on the codec.
Off: Set to Off to disable the IR sensor on the codec.
Auto: The system will automatically disable the IR sensor on the codec if the IR sensor at camera is
enabled. Otherwise the IR sensor on the codec will be enabled.
Example: SystemUnit IrSensor Mode: On
SystemUnit MenuLanguage
The setting is used to select the language for the GUI (Graphical User Interface).
Valuespace: <English/Norwegian/Swedish/German/French/Italian/Japanese/Russian/Spanish/Korean/
Finnish/ChineseSimplified/ChineseTraditional/PortugueseBrazilian/Turkish/Polish>
Example: SystemUnit MenuLanguage: English
SystemUnit Name
Enter a System Name to define a name of the system unit. If the H.323 Alias ID is configured on the system
then this ID will be used instead of the system name. The system name will be displayed:
* When the codec is acting as an SNMP Agent
* Towards a DHCP server
Valuespace: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: SystemUnit Name: “Meeting Room Name”
Time DateFormat
Specifies the date format.
Valuespace: <DD_MM_YY/MM_DD_YY/YY_MM_DD>
DD_MM_YY: The date January 30th 2009 will be displayed: 30.01.09
MM_DD_YY: The date January 30th 2009 will be displayed: 01.30.09
YY_MM_DD: The date January 30th 2009 will be displayed: 09.01.30
Example: Time DateFormat: DD _ MM _ YY
Time TimeFormat
Specifies the time format.
Valuespace: <24H/12H>
24H: Set the time format to 24 hours.
12H: Set the time format to 12 hours (AM/PM).
Example: Time TimeFormat: 24H
The Time settingsThe SystemUnit settings
Contact us
Contents
Introduction
Advanced configuration
Password protection
About monitors
Audio matters
Appendices
Advanced config.