Filter
Top Products
D14635.02—MARCH 2010
19
TANDBERG Codec C90 and Profiles using C90
Administrator guide
Contents Introduction Advanced configuration Password protection About monitors Audio matters Appendices Contact us
www.tandberg.com
GPIO Pin [1..4] Mode
The four GPIO pins can be configured individually. The state can be retrieved by “xStatus GPIO Pin [1..4]
State”. The default pin state is High (+12V). When activated as output, they are set to 0V. To activate them
as input, they must be pulled down to 0V.
Valuespace: <InputNoAction/OutputManualState/OutputInCall/OutputMicrophonesMuted/
OutputPresentationOn/OutputAllCallsEncrypted/InputMuteMicrophones>
InputNoAction: The pin state can be set, but no operation is performed.
OutputManualState: The pin state can be set by “xCommand GPIO ManualState Set PinX: <High/
Low>” (to +12V or 0V, respectively).
OutputInCall: The pin is activated when in call, deactivated when not in call.
OutputMicrophonesMuted: The pin is activated when microphones are muted, deactivated when not
muted.
OutputPresentationOn: The pin is activated when presentation is active, deactivated when presentation
is not active.
OutputAllCallsEncrypted: The pin is activated when all calls are encrypted, deactivated when one or
more calls are not encrypted.
InputMuteMicrophones: When the pin is activated (0V), the microphones will be muted. When
deactivated (+ 12V), the microphones are unmuted.
Example: GPIO Pin 1 Mode: InputNoAction
H323 Profile [1..1] Authentication LoginName
The system sends the Authentication Login Name and the Authentication Password to a H.323
Gatekeeper for authentication. The authentication is a one way authentication from the codec to the H.323
Gatekeeper, i.e. the system is authenticated to the gatekeeper. If the H.323 Gatekeeper indicates that no
authentication is required, the system will still try to register. Requires the H.323 Gatekeeper Authentication
Mode to be enabled.
Valuespace: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: H323 Prole 1 Authentication LoginName: “”
H323 Profile [1..1] Authentication Password
The system sends the Authentication Login Name and the Authentication Password to a H.323
Gatekeeper for authentication. The authentication is a one way authentication from the codec to the H.323
Gatekeeper, i.e. the system is authenticated to the gatekeeper. If the H.323 Gatekeeper indicates that no
authentication is required, the system will still try to register. Requires the H.323 Gatekeeper Authentication
Mode to be enabled.
Valuespace: <S: 0, 50>
Format: String with a maximum of 50 characters.
Example: H323 Prole 1 Authentication Password:
H323 Profile [1..1] Authentication Mode
Set the authentication mode.
Valuespace: <On/Off>
On: If the H.323 Gatekeeper Authentication Mode is set to On and a H.323 Gatekeeper indicates
that it requires authentication, the system will try to authenticate itself to the gatekeeper. Requires the
Authentication ID and Authentication Password to be defined on both the codec and the Gatekeeper.
Off: If the H.323 Gatekeeper Authentication Mode is set to Off the system will not try to authenticate
itself to a H.323 Gatekeeper, but will still try a normal registration.
Example: H323 Prole 1 Authentication Mode: Off
The H323 settingsThe GPIO settings
Contact us
Contents
Introduction
Advanced configuration
Password protection
About monitors
Audio matters
Appendices
Advanced config.