Filter
Top Products
D14635.02—MARCH 2010
16
TANDBERG Codec C90 and Profiles using C90
Administrator guide
Contents Introduction Advanced configuration Password protection About monitors Audio matters Appendices Contact us
www.tandberg.com
Cameras Camera [1..7] IrSensor
The Camera IR setting determines whether the infrared receiver at the camera should be enabled or not.
The IR sensor LED is located in the front of the camera and flickers when the IR sensor is activated from
the remote control.
Valuespace: <On/Off>
On: Set to On to enable the IR sensor on the camera.
Off: Set to Off to disable the IR sensor on the camera.
Example: Cameras Camera 1 IrSensor: On
Cameras Camera [1..7] Mirror
With Mirror mode (horizontal flip) you can mirror the image on screen.
Valuespace: <Auto/On/Off>
Auto: When the camera is placed upside down the image is automatically mirrored. Use this setting
with cameras that can be mounted upside down, and that can auto detect that the camera is mounted
upside down.
On: Set to On to see the selfview in mirror mode, e.g. the selfview is reversed and the experience of
selfview is as seeing yourself in a mirror.
Off: Set to Off to see the selfview in normal mode, e.g. the experience of selfview is as seeing yourself
as other people see you.
Example: Cameras Camera 1 Mirror: Off
Cameras Camera [1..7] Whitebalance Level
Define the Whitebalance Level for the selected camera. Requires the Whitebalance Mode to be set to
manual.
Valuespace: <1..16>
Range: Select a value from 1 to 16.
Example: Cameras Camera 1 Whitebalance Level: 1
Cameras Camera [1..7] Whitebalance Mode
Set the camera whitebalance mode.
Valuespace: <Auto/Manual>
Auto: When set to Auto, the camera will continuously adjust the whitebalance depending on the
camera view.
Manual: Set to Manual to enable manual control of the camera whitebalance, e.g. the level of the
whitebalance level setting will be used for the camera.
Example: Cameras Camera 1 Whitebalance Mode: auto
Cameras Camera [1..7] DHCP
Applies to cameras which supports DHCP, i.e the PrecsisionHD 1080p cameras. The camera must be
connected to a LAN. When set, the command enables support for SW upgrade of daisy chained cameras.
It will enable the camera’s DHCP function and force start of MAC and IP address retrieval. Remember to
reset the DHCP when the camera is no longer connected to a LAN.
Valuespace: <On/Off>
On: Set to On to enable DHCP in the camera. The camera is automatically re-booted. After re-boot the
DHCP is started and the IP address will be retrieved. Run the commnand “xStatus Camera” for result.
Off: Set to Off will disable DHCP in the camera. NOTE: When camera is not connected to a LAN, this
setting should be applied.
Example: Cameras Camera 1 DHCP: Off
The Camera settings, cont... The Camera settings, cont...
Contact us
Contents
Introduction
Advanced configuration
Password protection
About monitors
Audio matters
Appendices
Advanced config.