Filter
Top Products
Operating Basics
SDA 601 Serial Digital Analyzer User Manual
15
Video In/Out of range EDH flag set/not set
Line/field length (OK/incorrect)
Performing an Analysis — To analyze a signal, simply press
Ana-
lyze
. The SDA 601 will observe the incoming signal for one second,
analyze the data, and write the results to a “condition review list”
and the OSD.
Reviewing the results on the OSD — There are three pages of re-
sults; use the
B and Y keys, as indicated by the arrow icons on the
lower right of the OSD, to see all three pages.
Figure 6: The Analyze OSD
Reviewing the results on the LCD — Use the
B and Y keys to
scroll through the condition list on the instrument LCD. The display
will “time out” after three seconds of no key press and return to its
pre-analysis state—Idle, or the data enabled through the Display Se-
lect menu. Press
Enter to return to the last condition; press B or Y to
scroll down or up the list.
Printing an Analysis report — With a printer connected to the
RS-232 port and properly configured (see pages 35 and 36), press
Shift, then Analyze. A report, resembling the printout shown in Figure
3 (page 6), will be printed.