Filter
Top Products
EN
EN
Installation
13
Channel update
If new channels make their way into the audiovisual scene, you will have to update your
DMR’s list of channels. In such a case, start a new channel search from the installation menu.
This set-up deletes all stored channels and resets all the channels that your DMR can receive.
If you only want to set-up a single channel, refer to the manual search on page 12.
1. If the main menu is not displayed, press the
menu
key.
2. Select the Setup line using the ‡ or ˆ, keys, and press
ok
to validate.
3. Select the Installation line using the ‡ or ˆ, keys, and press
ok
to validate.
4. Select the Channel Search line using the ‡ or ˆ, keys, and press
ok
to validate.
Time set
Your DMR has an automatic time setting system which recognises the time signals put out by
certain channels. If your DMR is not set at the right time, you can reset it by following the
instructions below:
1. If the main menu is not displayed, press the
menu
key.
2. Select the Setup line using the ‡ or ˆ, keys, and press
ok
to validate.
3. Select the Installation line using the ‡ or ˆ, keys, and press
ok
to validate.
4. Select the Manual Clock line using the ‡ or ˆ, keys, and press
ok
to validate.
Sorting the channels
1. If the main menu is not displayed, press the
menu
key.
2. Select the Setup line using the ‡ or ˆ, keys, and press
ok
to validate.
3. Select the Installation line using the ‡ or ˆ, keys, and press
ok
to validate.
4. Select the Channel List line using the ‡ or ˆ, keys, and press
ok
to validate.
ð Refer to the Channel Sorting paragraph on page 11 to check or sort out the channels
stored on your DMR.
An installation window will appear. A blue
cursor shows the progress in the set-up of the
channels. When all the channels that you can
receive in your area have been stored,
100 %
is indicated. Press
ok
to return to the
Channel Search
line. Press
menu
to
return to the main menu.
Refer to the Time Setting paragraph on page
11 to set the time on your DMR.
DTH7000-EN 23/08/02 10:24 Page 13