Filter
Top Products
EN
EN
Settings
51
If the images of the DVD being played appear in black and white on your TV screen, the
standard of the video signals transmitted to your TV is incorrect. Change the video signal
from PAL to NTSC
(1)
or vice versa.
PAL or NTSC output
Choose the RGB, S-Video or Video
(2)
. signal, depending on the device connected to the
AV1 Scart socket (usually TV sets). If you don’t know which type of signal is accepted by
your TV
(3)
set, try each setting to get the best result.
AV1 output
Choose the RGB, S-Video or Video
(2)
. signal, depending on the device connected to the
AV2 Scart socket (usually a satellite receiver). If you don’t know which type of signal is
accepted by your TV set, try each setting to get the best result.
AV2 Input
This function automatically sets the time of your DMR’s internal clock. The correct time
setting of your DMR is important for the proper operation of your programmed recordings
and for optimum downloading of the NAVICLICK TV guide. Check that AutoClok is on
the On position.
Auto Clock
Your DMR has an Eco Standby to reduce its power consumption when on stand-by. Select
On to enable this function.
Stand-by mode
PAL is the name of the colour coding system used in most European countries. NTCS is the name of the
colour coding system used in the United States and some other countries.
1.
The Eco function does not allow the display of programming warning messages on the display panel.
Only the record icon will flash.
Display panel brightness
Depending on the brightness of the room where you’ve installed your DMR, select one of the
3 available settings (Automatic / Bright / Dim) to adapt the brightness of the display
panel to suit its environment.
Black level
Adjust the contrast (Light / Dark) according to the brightness of the room in which you are
viewing your DMR images.
Format of image signals:
RGB: Red - Green - Blue
S-Video: S-VHS (Y/C), signals with separate colour components and brightness.
Video: CVBS, composite video signals.
2.
Transmission of DMR images to TV images (with certain TV sets)
If you want to watch one channel while recording programmes on another channel, you must change the
AV1 output connection setting by selecting Video instead of RGB in the Options menu.
3.
DTH7000-EN 23/08/02 10:24 Page 51