Filter
Top Products
Installation
Rear connectors
18
The connection setup shown on page 8 provides rapid connection of your DMR. This
setup gives standard-quality sound reproduction and an optimum-quality picture (RGB).
Depending on the connectors available on your other devices or to get maximum
performance out of your DMR, you may need to use other connection setups. Your DMR
has other sockets for these purposes.
1 2 3 45 6 7 8 9 10 11 12 13
1. Antenna output to TV set.
2. Antenna input (cable or external antenna).
3. AV3 - S-VIDEO input
4. AV3 - Composite VIDEO input (CVBS)
5. Analog audio inputs
6. AV1 - SCART (RGB) connector to AV
amplifier or TV set
7. AV2 - SCART (RGB) connector to decoder,
satellite or cable receiver.
8. S-VIDEO Output (Ushiden socket Y/C
signal): to AV amplifier or TV.
9. S-VIDEO Output (Ushiden socket Y/C
signal): to AV amplifier or TV (standard-
quality picture).
10. Analog Audio Outputs to amplifier or
TV.
11. IR SAT/CABL Output to control a satellite
or cable receiver.
12-13 Digital Audio Outputs to amplifier or TV.
Audio connections (sound)
Video connections (picture)
Connections
The table below lists the connectors and quality of your DMR’s output signals. Select one
of the connection setups described for video connection and one of the setups described
for audio connection.
Sound quality Type of connector used
*** • OPTICAL
socket (13) (Toslink optical connector – digital signal)
*** • COAXIAL
socket
(12) (RCA socket- digital signal)
** • AUDIO L / R
socket
(RCA sockets- analog signal)
Picture quality Type of connector used
*** •
AV1(TV) (6) or AV2(SAT) (7) sockets (SCART socket–RGB signals)
** • S-VIDEO socket (Ushiden socket- Y/C signal)
* • VIDEO socket (RCA sockets- CVBS signal)
If the connecting cables are not supplied
with your DMR, get good quality cables. Opt
for known brands. The quality of the video
signals available on the SCART input and
output sockets can be adjusted (
k
page 51).
Connection through the scart socket supplies
both video and audio signals. If you choose
the connection using a scart cable, you don’t
need to connect any other sockets.
DTH7000-EN 23/08/02 10:24 Page 18