Filter
Top Products
12
Quick guide for menu operation
Make sure the aerial
connection and power supply
are connected as per the
description on page 9.
Preparations:
• Turn on the unit using
on the unit. The
Power indicator will light
up in green.
To change the unit to
standby mode, press
on the remote control.
Power indicator will
change from green to red.
To turn on the unit from
standby mode, press
on the remote control
again.
In standby mode, you can
also turn the unit on with
(Channel) on the
unit or (PAGE) on
the remote control.
To turn off the unit press
on the unit - to
completely switch it off,
disconnect the mains
power supply.
•Press TV/DVD to
select the TV mode.
•Press ATV/DTV to
toggle from analog TV or
digital TV mode.
Note:
• If no buttons are pressed
after approximately 60
seconds, the Main Menu
screen disappears.
Quick guide for menu operation
Example: When the DIGITAL MENU is pressed in ATV mode, it will automatically switch to
DTV mode. However, it is possible to use the MENU SETUP in the digital TV mode.
Launch the Main Menu screen by selecting Auto Tuning.
1
Press INPUT .
Select “ATV” or “DTV”, then press ENTER/CH LIST .
2
Press MENU SETUP in analog TV mode or press DIGITAL MENU in digital TV
mode to display the Main Menu screen.
3
Press to select “Channel“, then press
ENTER/CH LIST .
4
Press to select “Auto Tuning”, then
press ENTER/CH LIST to enter the Auto
Tuning menu.
5
Press to select your province/state, then
press ENTER/CH LIST .
6
Press to select “Start”, then press
ENTER/CH LIST
A message prompt will appear with option to delete
previously stored channels.
7
Press to select “Yes” or “No”, then
press ENTER/CH LIST .
The Auto Scan process will now begin.
A progress bar appears to indicate scanning
progress.
Note:
• ...on the following pages the Menu can be called
in the same way as here.
/
/
/
/
/
/
/
(Digital)