Filter
Top Products
29
EPG Timer (DTV mode only)
If you try to switch to another channel while a timer event is in progress, the following message will appear: ‘Warning: Changing
the channel will interrupt your event timer. Are you sure you want to proceed? Yes/No”. Select “Yes” or “No” according to your
wishes.
Notes:
• When the EPG Timer
starts, the message ‘Event
Timer Started’ will appear.
• If the EPG Timer starts
when it is already switched
on, it will start at the exact
time that is set. If it starts
from the standby mode, it
will begin 20 seconds in
advance of the stated
time.
• You cannot hasten the
start time from the original
start time of the Event.
• You cannot set with the
same date and time of
another Event.
• Press the Yellow/PLAY
MODE button to change
the start time of the event.
• Press the Blue/SLOW
button to change the time
duration of the event.
• When in power-off-
condition, EPG Timer
cannot be activated.
1
Press GUIDE to display the EPG menu.
2
Press / to highlight the programme you want to set as a timer event, then
press ENTER/CH LIST .
Notes:
• If you select an event which has already started, the selected programme will be
displayed on the screen, as you cannot set the timer for a programme which has already
started.
• To display the stored timer events, press GUIDE twice. The Event Timer menu (see step
3 below) will appear. You can also delete or change the frequency (Once / Daily /Weekly)
of the stored timer events (but please note that you cannot edit the time details that have
been set from the EPG).
3
A confirmation banner will be displayed.
Press to select ‘Yes’ or ‘No’, then press ENTER/CH LIST (the selected option
is shown in blue).
4
The Event Timer menu will appear.
Press the Red/SLOW button to set the
Timer mode for a selected event.
5
The Timer mode specifies the frequency of
Timer wake-up which can be set as Once,
Daily or Weekly.
Press ENTER/CH LIST to save the
selected Timer mode.
Note:
To delete a timer event, select the specified
event, then press the Green/PAUSE button.
6
To return to the EPG menu, press ENTER/CH LIST .
To clear the menu screen, press EXIT/CANCEL .
/
/
/