Filter
Top Products
16
Manual TV station presetting
If you like, you may manually tune a certain station into a selected programme position, without deleting or modifying program
position’s contents. The presetting applies to both analog and digital TV. Press the ATV/DTV button to enter ATV or DTV
mode then follow the steps to set the TV stations manually.
Note:
• Usually fine tuning is not
necessary, due to tuning’s
automatically stopping at
the very best position. If
you fine-tune anyway,
proper working of teletext-
reception with built-in
tuner is no longer
guaranteed.
Preparation:
Connect the aerial cable. Select programme position “2”. Press 2, OSD will indicate ‘2’ in left
upper corner. Eventually recently stored TV-channel’s name might also appear.
1
Press MENU SETUP or DIGITAL MENU to display the Main Menu screen
2
Press to select the “Channel” menu, then
press ENTER/CH LIST .
3
Press to select “Manual Tuning“, then press
ENTER/CH LIST .
4
In ATV mode:
Press to select “Search”, then press to start tuning. Tuning will stop
automatically at next received station.
If you like to use fine-tuning, select “Fine”. Press to fine tune. See the note on this
page.
In DTV mode:
You can select a channel number for the Channel List by pressing . The
corresponding tuning frequency for the channel will be set. Or, you can enter a frequency
value to start tuning.
After setting the channel, press ENTER/CH LIST to start scanning for channels.
A progress bar appears to indicate scanning progress and a list of the services (TV/radio)
collected from the channel will be listed.
/
/
/
/
/
/