Filter
Top Products
Chapter 6: Using the TV’s features
41
H-Position:
Moves the picture left/right.
The adjustment range is -50~+50 (default value is 0).*
V-Position:
Moves the picture up/down.
The adjustment range is -10~+10 (default value is 0).*
Clock:
Helps to reduce noise and sharpen the picture.
The adjustment range is -10~+10 (default value is 0).*
Phase:
Helps to reduce noise and minimize periodic vertical
stripes on the screen.
The adjustment range is -15~+16 (default value is 0).*
The default settings may vary depending on the input signal
format.
Setting the PC Audio
If the INPUT source is set to PC. The PC IN audio phone jack
is applied for PC IN when PC IN terminal is connecting with
an analog RGB cable. ( page 19)
Note: Because the PC Audio input is shared with HDMI 1.
If INPUT source is set to “HDMI 1,”And the HDMI 1 signal
is DVI format. This PC Audio input will apply for HDMI 1.
(Also see item 2 on page 11.)
•
•
•
•
*
Setting the sleep timer
You can set the sleep timer to turn off the TV after a set
length of time (maximum of 90 minutes).
To set the sleep timer using the remote control:
Press on the remote control to set the length of time until
the TV turns off. Repeatedly press to increase the time in
30-minute increments, to a maximum of 90 minutes.
To set the sleep timer using the on-screen menus:
Press and open the Prefer menu.
Highlight Sleep Timer.
Press or to increase the time in 30-minute
increments.
Off30 Min60 Min90 MinOff
Note: When a power failure occurs, the sleep timer setting
may be cleared.
To display the remaining sleep timer:
Press on the remote control or same as above process
using the on-screen menus.
To cancel the sleep timer:
Repeatedly press until it is set to Off.
1�
2�
3�