37
EN
Satellite Link
You can set the unit to start recording whenever it
detects the video scart control from the external tuner.
Preparing for the Satellite Link Timer Recording:
[Preparation of the external tuner]
• The external tuner should be equipped with
some kind of timer function. Using timer function
of the tuner, set it to be turned on when it comes
to the time you want to start recording, and off
when it comes to the time you want to finish
recording. (Refer to the tuner’s manual on how
to set the timer.)
• Make sure to turn off the external tuner when
you finish setting.
[Preparation of this unit]
• Make sure to select the desired Recording
mode beforehand.
1 In stop mode, press [HDD] then
select the recording mode for HDD
using [REC MODE].
2 Press [SAT.LINK].
• “Sat” will appear on the front panel display and
the unit goes into the Satellite Link standby
mode.
To cancel the Satellite Link function in the
Satellite Link standby mode:
Press [B ON\STANDBY] or [SAT.LINK] to turn on
the unit.
To cancel the Satellite Link function while the
Satellite Link Recording is in progress:
Press [C STOP] on the front panel of the unit, or
press and hold [STOP C] on the remote control for
2 seconds.
Note
• Recording picture will be distorted if the copy
protection signal is being detected during Satellite
Link Timer Recording.
• [SAT.LINK] does not work under the following
circumstances:
- Setup menus are displayed.
- “Timer Programming” menu is displayed.
- Title list or any file list is displayed.
• When a regular Timer Recording and the Satellite
Link Timer Recording are overlapped, the examples
are given below.
HDDHDD
HDMI OUT
Scart cable (not supplied)
External tuner
(not supplied)
Example 1
Example 2
Example 3
Timer
Recording
Satellite Link
Actual
Recording
Timer
Recording
Satellite Link
Actual
Recording
Timer
Recording
Satellite Link
Actual
Recording
Introduction Connections Basic Setup Playback Editing OthersFunction SetupRecording VCR Functions
E3LG0ED_EN.book Page 37 Wednesday, April 30, 2008 11:52 AM