Filter
Top Products
35
EN
Skip the Periodical Timer Recording
You can deactivate the periodical (Daily, Mon-Fri or
Weekly) timer recording temporarily.
1 In stop mode, press [TIMER PROG.].
2 Select the periodical timer recording
programme you want to skip using
[U \ D], then press [ENTER].
3 Select “Programme Change” using
[U \ D], then press [ENTER].
4 Move the cursor to the “Skip” field
using [L \ P], then select “ON” using
[U \ D] and then press [ENTER] to
activate the setting.
• “✔” will be displayed on the left side of the timer
programme.
• The setting will go back to “OFF” after the
programme is skipped once.
Stop the Timer Recording in Progress
On the front panel of the unit, press
[C STOP] to stop the recording, or
press and hold [STOP C] on the remote
control for 2 seconds.
• You can also stop the timer recording in progress by
deleting the timer programme. Press
[TIMER PROG.] while the timer recording is in
progress, then follow steps
2-A) and 3 of the
“Checking, Cancelling or Correcting the Timer
Programming Information” on page 34.
If the Timer Programming Did Not
Complete Correctly
The error number appears on “Timer Programming”
list.
The error programme will be displayed in grey
with an error number.
The error numbers indicate:
• Timer programme with an error number will be
cleared once the entry screen for the
programme is displayed.
1/1
E40
06/12 7:00 9:00
P01
06/120:00
VPS
PDC
Timer Programming
THU
Date Start End
New Programme
CH
E1–E22,
E37–E39 : Recording error
E23–E24 : Unrecordable disc
E25/E51 :
:
• Copy prohibited programme
• Cannot record because of the NTSC
/ PAL-60 signal is received.
E26–E28 : Copy prohibited programme
E29 : Disc protected
E30 : Disc full
E31 : Already recorded 99 titles (Video
mode)
E32 : Already recorded 99 titles (VR mode)
E33 : Already recorded 999 chapters
E34 : No space for Control Information
E35 : PCA (Power Calibration Area) full
E36 : Already finalised Video format disc
E40 :
:
• There are some unrecorded parts
due the overlapped timer
programmes.
• Recording did not start at the start
time.
E41 : Power failure
E42 : No disc
E43 : Already 49 titles recorded
(+VR mode)
E44 : Already 254 chapters recorded
(+VR mode)
E45 : Copy prohibited programme
E46 : It is impossible to record additionally
on a disc recorded by other units
when setting “Make Recording
Compatible” to “OFF”. (+VR mode)
E47 : Already 600 titles recorded on the
HDD.
E49–E50 : HDD recording is cancelled due to the
insufficiency of the disc space on the
HDD.
Introduction Connections Basic Setup Playback Editing OthersFunction SetupRecording VCR Functions
E3LG0ED_EN.book Page 35 Wednesday, April 30, 2008 11:52 AM