Filter
Top Products
53
Function setup (DVD)
■ DivX(R) VOD
In order to play DivX
®
VOD (Video On Demand) content
on this unit, you first need to register the unit with your
DivX
®
VOD content provider. You do this by generating a
DivX
®
VOD registration code, which you submit to your
provider.
Press ▲ or ▼ to select “DivX(R) VOD”. Then press
ENTER. Your 8-character registration code is
displayed. Make a note of the code as you will need
it when you register with a DivX
®
VOD provider. Then
press ENTER.
■ Set the new password
1) Press ▲ or ▼ to select “Password”, then press ENTER.
“Enter Current Password” screen will appear.
2) Press Number buttons (0–9) to input the current
password (If the password has not been set yet after
you purchase this unit, it is “0000”).
3) Then press ENTER. “Enter New Password” screen
will appear. Press Number buttons (0–9) to input the
new password.
4) Press ENTER. Now your new password has been set.
Be sure to remember this number!
If you forget the password.
1) Press OPEN/CLOSE to open the disc tray.
2) Remove the disc.
3) Press OPEN/CLOSE again to close the disc tray.
“No Disc” appears on the screen.
4) While holding 7 down on the remote control and at the
same time press STOP on the front panel. “Password
Clear” appears on the screen. Now the password has
been returned to the initial value (“0000”).
■ Output
You can select the video output signal of the DVD video
player to the TV from “Interlace” or “Progressive”.
Interlace:
Select when connecting to a composite TV or
a TV equipped with component video inputs
but progressive scan is not compatible.
Progressive:
Select when connecting to a TV equipped
with component video inputs and progressive
scan compatible.
Warning:
Once “Progressive” is selected when connecting to a TV
progressive scan incompatible, no image will be seen on
the video display.
In this case, you must reset the unit by pressing STOP,
on the front panel for five seconds. The video output will
be restored to “Interlace” setting, and a picture will once
again be seen on a conventional analog display.
Notes:
Some discs may not be played back with the progressive
scanning mode correctly because of the disc
characteristics or recording condition.
Once Progressive scan on, S-video output is disabled.
•
•
Note:
If each setup (pages
50
~
53
) has completed, the unit
can always work under the same condition (especially
with DVD discs).
Each setup will be retained in the memory even if you
turn the power off.
2K10101A.indb 532K10101A.indb 53 12/22/2006 5:12:14 PM12/22/2006 5:12:14 PM