Filter
Top Products
103
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 42/50HP95 *web 213:276
Chapter 10: Troubleshooting
General troubleshooting (continued)
Symptom Solution
Recording problems • If you use the TV’s remote control to start recording, you will not be able to change inputs (page 69),
open the POP window (page 78), or open the FAV SCAN multi-window (page 80). If you attempt to do
so, the message “Not Available While Recording” will appear on-screen.
• If you are recording a digital channel, you will only be able to change analog channels while the recording
is in progress. If you are recording an analog channel, you will only be able to change digital channels
while the recording is in progress. This is because the TV tuner that is being recorded (digital or analog)
will be locked on the channel that is currently recording.
• It is recommended that you use the TV’s remote control to start recording. If you use a device other than
the TV’s remote control to start recording and then attempt to access a feature that is normally denied
during recording (POP mode, FAV SCAN mode, changing inputs,) the recorded audio and/or video may
not be what you intended to record. See pages 69 and 73.
•If
you connected a Symbio™ AVHD recorder, in order to use its full functionality, you must first set up the
TV Guide On Screen™ system (page 24 and Chapter 5).
TV stops responding to controls • If the TV stops responding to the controls on the remote control or TV side panel and you cannot turn off
the TV, press and hold the POWER button on the TV side panel for 5 or more seconds to reset the TV.
Other problems • If your TV’s problem has not been addressed in this Troubleshooting section or the recommended
solution has not worked, use the Restore Factory Defaults procedure as described on page 54.
#01E_101-106_4250HP95 05.9.12, 10:11 PM103
Black