Filter
Top Products
9
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
(E) 42/50HP95 *web 213:276
1. Carefully read the important safety, installation, care,
and service information on pages 2–5. Keep this
manual for future reference.
2. Observe the following when choosing a location for
the TV:
•
Place the TV on the floor or a sturdy, level, stable surface that can
support the weight of the unit. Secure the TV to a wall, pillar, or
other immovable structure as described on page 3, item 19.
• Place the TV in a location where light does not reflect on the
screen.
• Place the TV far enough from walls and other objects to allow
proper ventilation. Inadequate ventilation may cause
overheating, which will damage the TV. THIS TYPE OF
DAMAGE IS NOT COVERED UNDER THE TOSHIBA
WARRANTY.
• Read “Installation” on pages 3–4.
• Read “Important notes about your Plasma TV” on page 5.
3. Do not plug in any power cords until AFTER you have
connected all cables and devices to your TV.
4. BEFORE connecting cables or devices to the TV, learn
the functions of the TV’s connections and controls (pages 10
and 11).
5. Connect your other electronic device(s) to the TV
(pages 13–27).
6. Connect the G-LINK™ cable (either one of the enclosed IR
blaster cables) from your VCR and/or Cable box (if applicable)
to the G-LINK™ terminal so you can use the TV Guide
On Screen™ features (applies to VCRs and cable boxes only).
See page 26.
7. Install the batteries in the remote control (page 30).
8. See “Learning about the remote control” (pages 28-29)
for an overview of the buttons on the remote control.
9. Program the remote control to operate your other
device(s) (pages 30–36).
Overview of steps for installing, setting up, and using your new TV
Follow these steps to set up your TV and begin using its many exciting features.
Chapter 1: Introduction
Note:
If you sell or transfer this television to a third party, be sure
to reset the PIN code as described on page 97 under the heading,
“If you cannot remember your PIN code.”
10. AFTER connecting all cables and devices, plug in the
power cords for your TV and other devices.
“Now Booting...” will be displayed on the screen until the picture
appears or the green LED will blink until the TV goes into
standby mode.
When the TV is in standby mode, press POWER on the TV side
panel or remote control to turn on the TV.
11. See “Menu layout and navigation” for a quick overview
of navigating the TV’s menu system (pages 37–38).
12. See Chapter 5 for details on setting up the TV Guide
On Screen™ system (if available in your area).
13. See Chapter 7 for details on using the TV Guide
On Screen™ program guide (if available in your area).
14. Program channels into the TV’s channel memory
(page 44).
15. Set up the TheaterNet™ on-screen device control
feature (if applicable to your particular home theater system
components) (page 47).
16. For details on using the memory card JPEG picture
viewer and MP3 audio player, see page 89.
17. For details on using the TV’s features, see Chapter 8.
18. For help, refer to the Troubleshooting Guide (Chapter
10).
19. For technical specifications and warranty information,
see Chapter 11.
20. Enjoy your new TV!
If the TV stops responding to the controls on the remote control
or TV side panel and you cannot turn the TV off or on, press
and hold the POWER button for 5 seconds to reset the TV.
#01E_008-009_4250HP95 05.9.12, 10:05 PM9
Black