Filter
Top Products
18
Using Your Remote Control
Your new remote can control up to four devices. To select the device you’d like
it to control, simply press one of the device keys (TV, AUDIO, DVD/VCR or
CABLE) at the top of your remote. Then follow programming instructions below.
Programming Device Control
Each of the additional device keys controls a particular type of device. For
example, the DVD/VCR key controls your VCR, DVR or DVD player, but not your
TV, unless you specify otherwise. ( See Reassigning Device Keys on page 20.)
To specify a device:
1.
Look up the device you want to control in the device code list included in this
Guide (see pages 22–27).
2. Press and hold a device key (AUDIO, DVD/VCR or TV) for at least six
seconds. The LEDs for each device key light up momentarily and the LED
for the device you selected remains on.
3. Enter the four-digit code. The device key LED turns off briefly after each key press.
NOTE: You have 10 seconds to press each digit. If you take longer than that, the
remote “times out” and you must begin again.
4. If the remote recognizes the code, the device key’s LED blinks three times.
You can now test the remote by pressing POWER. If your device responds
(i.e., turns off), you have found the right code. If your device does not
respond, repeat steps 2 and 3 with the next code on the list.
If the remote does not recognize the code, the LED will turn off. Retry the code
(by repeating steps 2 and 3 using the next code listed for your brand) or search
for a new device code. (See Searching for Codes below.)
Searching for Codes
If none of the codes listed in this guide match your device, you can search for a
set of commands that will work.
1. Press and hold a device key (AUDIO, DVD/VCR or TV) for at least six
seconds. The LED for each device key lights up momentarily and the key
for the device you selected remains on.
2. Press a function key (such as Power or Mute). The following function keys
are valid for searching (POWER is recommended):
• POWER • MUTE • PLAY • CH+ • STOP
The device key’s LED blinks three times, then turns off.
This Device Key
Controls This Type of Device
TV TV
DVD/VCR DVD, VCR, DVR, HTS and Combination sets
CABLE FiOS TV Set Top Box only
AUDIO Amplifier, Tuner