Filter
Top Products
VXI Technology, Inc.
26 SVM2608 Preparation for Use
Example 2
OV
(decimal)
Divide
by 16
MSB LSB
200 200 / 16 = 12 w/ 8 remaining Divide by 16.
= 1100 1000 Convert to MSB and LSB.
= C 8 Convert to hexadecimal. Set the back
switch to C and the front switch to 8.
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
S
2
S
3
FIGURE 2-3: OFFSET VALUE EXAMPLE 2
Therefore, the base address in this example is:
A32 Base Address = 0xC8 * 0x1000000 (or 16,777,216)
A32 Base Address = 0xC8000000
This information is used to write to the registers of the SVM2608. (See
Section 3 for more details
on SVM2608 registers.)
MODULE INSTALLATION/REMOVAL
Before installing an SVM2608 module into a 6U VME mainframe, make sure that the mainframe
is powered down. Insert the module into the base unit by orienting the module so that the flanges
at the edge of the module can be inserted into the slot of the base unit. Position the flanges so that
they fit into the module slot groove. Once the module is properly aligned, push the module back
and firmly insert it into the backplane connector. The retaining screws can then be used to secure
the module in the chassis.
To remove the module, power down the mainframe and remove all cabling from the module. The
retaining screws can then be loosened. The ejector handles can then be used as to assist in the
removal of the module.