TOSHIBA - 22
TX Series 48 - 1250A
4.2.1 Password Access
Screens in Level 1 of the setpoint menu can be changed without password
access because they list basic motor information. Screens in Levels 2
and 3 require passwords because they provide more in-depth protection
and control of the TX Series unit. The password in Levels 2 and 3 can be
changed by the user.
NOTE: Setpoints can only be changed when the motor is in Stop/
Ready Mode! The TX will not allow a start if it is still in the
Edit Mode. When the unit is in the Edit Mode, a “*” is in the
top right corner of the display.
4.2.2 Changing Setpoints
Example 1: Changing Motor FLA
A. Press MENU button to display Setpoint Page 1, Basic Configuration
B. Press the RIGHT ARROW you will view the screen Motor Full Load
Amps.
C. Press the ENTER button for edit mode. Note the asterisk (*) in the
top right corner of the LCD screen that indicates Edit Mode.
D. To change the value, select the UP ARROW or DOWN ARROW.
E. To accept the new value, press the ENTER button. The unit will
accept the changes and will leave the edit mode. Note the * is no
longer in the top right corner of the LCD Display.
MENU
PAGE 1 BASIC
CONFIGURATION
MOTOR FULL LOAD AMPS
: 140 AMPS
MOTOR FULL LOAD AMP*
: 142 AMPS
2x
ENTER
ENTER
MOTOR FULL LOAD AMP
: 142 AMPS
