TOSHIBA- 57
TX Series 48 - 1250A
6.1 Metering Page List
The following charts list each Metering Page and the functions within that page.
The applicable section of the manual is also referenced.
6.1.1 Metering Menu & Data (Metering Page 1)
Chapter 6 - Metering Pages
The TX Series offers performance metering which gives the user the ability to view
information about the motor and the TX unit.
6.1.2 Metering (Metering Page 2)
6.1.3 RTD Values (Metering Page 3)
Metering
Page
Description of Display Screen
Phase A, B, C and Ground Fault 1
Average current of the % of imbalance and the motor's RPM 2
Motor load as a percentage of motor FLA 3
Line frequency and present phase order 4
Percentage of remaining Thermal Register 5
Thermal capacity required to start the motor 6
Average time required to start 7
Average current during start 8
Measured I
2
T required to start the motor
9
Amount of time required to start the motor during the last successful start 10
Page 1
Metering Menu & Data
Metering
Page
Description of Display Screen
Phase A, B, C and Power Factor 1
Phase A, B, C and Ground Fault 2
Displays KW and KVA 3
Displays KVAR and Power Factor 4
Displays Peak ON and KW Demand 5
Displays Peak ON and KVA Demand 6
Displays Peak ON and KVAR Demand 7
Displays Peak ON and Amps Demand 8
Clears Demand values 9
Displays Megawatt hours used 10
Press enter to clear statistics on MWH values 11
Page 2
Metering
Metering
Description of Display Screen
Hottest stator RTD (#1 - 6) 1
Hottest non-stator RTD (#7 - 12)
2
Temperature of start phase A1 in °C and °F 3
Maximum temperature for RTD #1 4
Same as Screens 3 - 4 5 - 26
Clear the maximum temperature register (Level 3 password required) 27
Measured run cool time in minutes
28
Measured stopped cool time in minutes
29
Page 3
RTD Values
