TOSHIBA- 41
TX Series 48 - 1250A
SP.4 Relay Assignment (Setpoint Page 4)
(Security Level: 2)
All of the protection functions of the TX are user programmable to an
output relay. The factory will ship with all tripping functions assigned to
TRIP (AUX1) relay, and all alarm functions to ALARM (AUX2) relay. Note:
AUX1 - 4 are Factory Set and should not be changed.
SP4.1 The following is a list of all the user programmable functions.
Note: The Relay Assignments are factory defaults.
FUNCTIONS RELAY ASSIGNMENT
IMBALANCE TRIP TRIP (AUX1)
SHORT CIRCUIT TRIP TRIP (AUX1)
OVERCURRENT TRIP TRIP (AUX1)
STATOR RTD TRIP TRIP (AUX1)
NON-STATOR RTD TRIP TRIP (AUX1)
GROUND FAULT HI SET TRIP TRIP (AUX1)
GROUND FAULT LO SET TRIP TRIP (AUX1)
PHASE LOSS TRIP TRIP (AUX1)
ACCELERATION TIME TRIP (AUX1)
START CURVE TRIP TRIP (AUX1)
OVER FREQUENCY TRIP TRIP (AUX1)
UNDER FREQUENCY TRIP TRIP (AUX1)
I*I*T START CURVE TRIP (AUX1)
LEARNED START CURVE TRIP (AUX1)
PHASE REVERSAL TRIP
OVERVOLTAGE TRIP TRIP
UNDERVOLTAGE TRIP TRIP
POWER FACTOR TRIP TRIP
TACH ACCEL TRIP TRIP
INHIBITS TRIP TRIP
SHUNT TRIP AUX 3
BYPASS DISCREPANCY NONE
EXTERNAL INPUT 1 NONE
EXTERNAL INPUT 2 NONE
DUAL RAMP NONE
THERMOSTAT TRIP (AUX 1)
OVERLOAD WARNING ALARM (AUX2)
OVERCURRENT ALARM ALARM (AUX2)
GROUND FAULT ALARM ALARM (AUX2)
UNDERCURRENT ALARM ALARM (AUX2)
MOTOR RUNNING NONE
IMBALANCE ALARM ALARM (AUX2)
STATOR RTD ALARM ALARM (AUX2)
NON-STATOR RTD ALARM ALARM (AUX2)
RTD FAILURE ALARM ALARM (AUX2)
SELF TEST FAIL TRIP (AUX1)
THERMAL REGISTER ALARM (AUX2)
U/V ALARM ALARM
O/V ALARM ALARM
POWER FACTOR ALARM ALARM
KW DEMAND ALARM ALARM
KVA DEMAND ALARM ALARM
KVAR DEMAND ALARM ALARM
AMPS DEMAND ALARM ALARM
TIMED OUTPUT NONE
RUN DELAY TIME NONE
AT SPEED AUX4
