TOSHIBA - 28
TX Series 48 - 1250A
5.1.7 Custom Acceleration Curve (Setpoint Page 7)
5.1.8 Overload Curve Configuration (Setpoint Page 8)
Setpoint
Page
Security
Level
Description
Factory Setting
Default
Range Section
Custom Accel Curve Disabled Disabled, Curve A, B, or C
Custom Curve A
Curve A Voltage Level 1 25% 0-100%
Curve A Ramp Time 1 2 sec 1-60 sec
Curve A Voltage Level 2 30% 0-100%
Curve A Ramp Time 2 2 sec 1-60 sec
Curve A Voltage Level 3 37% 0-100%
Curve A Ramp Time 3 2 sec 1-60 sec
Curve A Voltage Level 4 45% 0-100%
Curve A Ramp Time 4 2 sec 1-60 sec
Curve A Voltage Level 5 55% 0-100%
Curve A Ramp Time 5 2 sec 1-60 sec
Curve A Voltage Level 6 67% 0-100%
Curve A Ramp Time 6 2 sec 1-60 sec
Curve A Voltage Level 7 82% 0-100%
Curve A Ramp Time 7 2 sec 1-60 sec
Curve A Voltage Level 8 100% 0-100%
Curve A Ramp Time 8 2 sec 1-60 sec
Curve A Current Limit 350% FLA 200-600%
Custom Curve B
Same Programmable Data Points and Ranges
as Custom Curve A
Custom Curve C
Same Programmable Data Points and Ranges
as Custom Curve A
Page 7
Custom Acceleration Curve
Level 3
Password Protection
SP7.1
Setpoint
Page
Security
Level
Description
Factory Setting
Default
Range Section
Basic Run Overload Curve
Run Curve Locked Rotor Time O/L Class 1-30 sec, O/L Class
Run Locked Rotor Current 600% FLA 400-800%
Coast Down Timer Disabled 1-60 Min, Disabled
Basic Start Overload Curve
Start Curve Locked Rotor Time O/L Class 1-30 sec, O/L Class
Start Locked Rotor Current 600% FLA 400-800%
Acceleration Time Limit 30 sec 1-300 sec, Disabled
Number of Starts Per Hour Disabled 1-6, Disabled
Time Between Starts Time Disabled 1-60 Min, Disabled
Area Under Curve Protection Disabled Enabled or Disabled
Max I*I*T Start 368 FLA 1-2500 FLA*FLA*sec
Current Over Curve Disabled Disabled, Learn, Enabled
Learned Start Curve Bias 10% 5-40%
Time for Sampling 30 sec 1-300 sec
Level 3
Password Protection
Page 8
Overload Curve Configuration
SP8.1
SP8.2
SP8.3
SP8.4
