Filter
Top Products
Cyclades-PR4000
Chapter 7 - The E1 and T1 Interfaces, Without Signaling 52
CHAPTER 7 THE E1 AND T1 INTERFACES, WITHOUT SIGNALING
The menus relating to configuration of the E1 and T1 interfaces without signaling are given in this chapter. T1 is
a standard used in the United States, Canada, and Japan. It has a clock speed of 1.5MHz and has 24 channels
of 64K each. One of the channels is reserved for signaling when ISDN/PRI is used. E1 is a standard used in
Europe and many other countries. It has a clock speed of 2MHz and has 32 channels with two reserved for
signaling. Aside from this, there are few differences between the two standards in terms of configuration.
The Controller menu tree for the PR4000 (for Signaling Mode = None) is shown in figure 7.1
Frame Mode
Line Code
Signaling Mode
Clock Mode
Line Build Out
Receiver Sensitivity
Companding Mode
Add Group
Delete Group
Edit Group
Clear All Groups
Config
Controller
T1/E1
Timeslot
Timeslot Allocation
Timeslot Start
Timeslot End
Timeslot N
Channel Group Number
Channel Group Number
Rest Same as Add Group
FIGURE 7.1 PR4000 CONTROLLER MENU TREE