Barco 70 Projection Television User Manual


 
3. Connections
How to configure the 5-cable input ?
1. Press ADJ or ENTER to open the Main menu. (menu 3-1)
2. Push the cursor key or to select Installation and press ENTER.
The installation menu will be displayed. (menu 3-2)
3. Push the cursor key or to select Input slots and press ENTER.
The input slots menu will be displayed. (menu 3-3)
4. Select 5 RCA and toggle ENTER to switch between YUV, RGB and SCART.
Select RGB for the following source types:
-RGBHV
-RGBS
-RGsB
Select YUV for the following source types:
- Component sources
Select SCART for the following source types:
- RGB+Video
Main Menu
Image settings
Advanced settings
Installation
Service
1. PC
2. RGB/Component
3. DVI
4. SVideo
* 5. Video
6. Component
Shutdown
Back
Menu 3-1
Installation
Input slots
File service
Internal pattern
When no signal
Source transition
OSD configuration
Language
V-Keystone
H-Keystone
Global keystone
Orientations
Back
Menu 3-2
Input slots
5 RCA
YUV
Reset single slot
PC
RGB/Component
DVI
SVideo
Video
Component
Reset all slots
All input slots
Back
Menu 3-3
3.7 Component Input
Input specifications and locations
The component input section is made of 3 RCA input terminals.
Input signals : Pr, Pb, Ys
0.7Vpp ± 3dB
75 terminated
ASPECT
RATIO
12V TRIGGER
SCREEN
S-VIDEO VIDEO V
H
R/Pr
B/Pb
G/Y
Pr Pb Y
RS232/RS422
IN
CONTROL
DVI INPUT
VGA INPUT
COMPONENT
VIDEO INPUT RGB/COMPONENT INPUT
Image 3-7
Component input
How to select the component input ?
1. Press 6 on the RCU.
Note: Another way of selecting the component input is entering the Main menu and selecting C
omponent.
20
R5976763 CINEVERSUM 60/70 22042004