Clover Electronics CDR 4170 DVR User Manual


 
8.2 CAMERA
This product can be installed up to 4 cameras.
Connect cameras to the VIDEO IN (BNC) on the back panel of the product.
To connect a PTZ camera, connect the PTZ camera’s control line to the RS-485 (+, -) terminal
and connect the video output to one out of VIDEO IN on the back panel of the product.
CH1 CH2 CH3 CH4
LOOP OUT
VIDEO IN
V - OUT1 A - IN
A - OUT
ETHERNET
ALARM IN
1234
GND
+
_
ALARM OUT
AC INPUT
AC100-240V,50/60Hz
POWER
ATTENTIONCAUTION
RISQUE DE CHOC ELECTROIQUE
NE PAS ENLEVER
DO NOT OPEN
RISK OF ELECTRONIC SHOCK
RS485
V - OUT2
MODEL NO : CDR4170
AC100-240V,50/60Hz, 25W
CLOVER ELECTRONICS
13073 EAST 166TH STREET, CERRITOS, CA 90703
Factory ID/DHHS CODE : BC
R
C US LITED
E233232
AUDIO/VIDEO EQUIPMENT 2UW2
ELECTRONICS U.S.A
CLOVER
PTZ CAMERA
CAMERA (BNC)
8.3 AUDIO
The system has one channel audio input and output. If you wish to record and playback audio
signal, connect the proper audio device (microphone) to the AUDIO IN (1 Vp-p @600 ohms) and
speaker to the AUDIO OUTPUT (See illustration below).
NOTE
A LOOP OUT is a looping output trough VIDEO IN. Therefore the monitor for
looping output can be used only when there is video signal on the VIDEO IN.
- 41 -