Filter
Top Products
41
If the light on your Sky remote control blinks three times, your Sky
digibox has checked all the possible settings for the code you used.
Check that you have the correct 4 digit code and start again at Step 1.
7. Turn your TV back on again and then press tv guide.
If you see the TV Guide screen, the remote control setup process is
complete.
If you do not see the TV Guide screen, you must now complete the
following steps.
8. Press tv on your Sky remote control.
9. Hold down select and the green key at the same time for
about two seconds, until the red light on the Sky remote control
blinks twice.
10. Key in the number of the TV channel that you use for watching
satellite TV.
11. Press select on your Sky remote control. The red light blinks
twice. The remote control setup process is complete.
If after doing this, you still have problems, call your broadcaster’s
helpdesk. For your broadcaster’s helpdesk number, select the
Telephone Numbers option from the Services screen.
EXTRA INFORMATION