Filter
Top Products
dCS 954 User Manual Manual for Standard Software Version 1.5x
dCS Ltd June 2000
Manual part no: DOC136954 iss 2B1
Page 16
file 135954ma2b1.pdf available from website
Contact
dCS
on + 44 1799 531 999 email to: more@dcsltd.co.uk
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
Sample Rate Display -
The main display generally shows the incoming sample rate, in kS/s, or the
mode (DSD). When other parameters are set, it briefly shows the new setting
(volume, tone frequency, etc) then reverts to its normal display. In the case of an
error condition, it will display an error message.
If the unit is being slaved to a reference source, the display also indicates which
reference input it is slaved to.
xxx The sample rate, in kS/s (32, 44.1, 48, 88.2, 86,
176.4, or 192).
b xxx Slaved to the BNC Word Clock In.
r xxx Slaved to AES Reference In.
d xxx Temporary display during locking – the unit has
detected the base reference sample rate and is
attempting to lock to it.
. xxx Temporary display during locking – the unit is lining
up word clock out to word clock in.
Important error messages are given below – a full list is given in the section
“Error Codes and Messages” on page 76.
BadFs The clock source is not in pull in range, or is poorly
formatted. The unit cannot lock to it.
Err.xy An error has been detected. Please refer to
“Internal Device Error Codes” on page 76 for
more specific details on error codes.
Hot The unit is overheating, probably due to inadequate
ventilation. Please check positioning and cooling.
Ouch The “Hot” warning has been ignored and the unit is
getting so hot that damage may follow.
(blank) If the display is completely blank for any significant
period, try switching off for 10 seconds then
switching on again. If this does not solve the
problem, contact your distributor or dCS.
The display is also used for Menu options.