Filter
Top Products
dCS 954 User Manual Manual for Standard Software Version 1.5x
dCS Ltd June 2000
Manual part no: DOC136954 iss 2B1
Page 76
file 135954ma2b1.pdf available from website
Contact
dCS
on + 44 1799 531 999 email to: more@dcsltd.co.uk
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
T
ROUBLE
S
HOOTING
Error Codes and Messages
The error codes and messages reported by dCS 954 provide an effective means
to diagnose the majority of problems that may be encountered in use - including
problems with the overall system the unit operates in, internal device warnings
and internal device failures. Please note that through damage or component
failure, the unit self check may fail to operate. If this happens, please contact
your distributor or dCS for assistance.
Internal Device Error Codes
Sometimes the unit may misbehave. If there is an internal reason, an internal
device error code may be displayed as follows:
Err.xy an error xy (see table below) has been detected
where xy values have the following meanings:
Code Description
01 E
2
memory (EEPROM) not present
02 Error initialising DSP
03 Error loading DSP
04 Error initialising DSP for coefficients
05 Error initialising DSP for coefficients
06 Error loading DSP coefficients
07 Error loading DSP coefficients
08 Error sending command
09 Error sending command
10 Error sending command
11 Error sending command
12 Error with LSB/MSB configuration
13 Error with LSB/MSB configuration
14 Error with LSB/MSB configuration
15 Error configuring FPGA
99 DSP error
Table 13 – Internal Error Codes
If you get any of these, please contact dCS, with as much information as
possible to help us re-create the problem. Some of these may have hardware
problems as their cause, some may have software.