Filter
Top Products
dCS 954 User Manual Manual for Standard Software Version 1.5x
dCS Ltd June 2000
Manual part no: DOC136954 iss 2B1
Page 73
file 135954ma2b1.pdf available from website
Contact
dCS
on + 44 1799 531 999 email to: more@dcsltd.co.uk
(inside the UK replace + 44 with 0) web site: www.dcsltd.co.uk
Software
Installing New Software
Updated operating software can be downloaded via the RS-232 link from a PC
comm. port, using the Windows Remote software running on the PC, or can be
copied from an EPROM installed internally.
Using the RS-232 download is hands free, but takes about 40 mins per unit.
With special software (contact dCS) multiple units can be daisy chained together
so that one PC can update them all serially (overnight).
To update the software by the RS-232 link, load the new software into a
convenient directory on the PC, then run the Windows Remote programme with
whatever units you want connected. The software will scan the RS-232 chain for
units (this takes a while) to see what it thinks is connected, and then reports
back. For each unit there is an Info button. Select the Info button for the unit
you wish to update, and then select Download Flash. The programme will
prompt you for the file to use, and then will start the download. If you want to
programme many units automatically (say overnight) contact dCS for special
software to enable this function.
IMPORTANT!
Do not turn the unit off until the download is complete. The unit has to erase
its current programme before it can store the new one, so if the power is
turned off, its internal programme store will have been erased but no new
programme installed. Contact dCS if this happens inadvertently – the
situation can be recovered if it does happen, but it involves taking the lid off
the unit.
To find out if there are any software updates available for your equipment, call
us, or email us, with your units serial number, or check our web site
(www.dcsltd.co.uk). In general, software updates are free. Manuals for updated
software can be downloaded from our web site, or just call us.
During An Update …
As soon as the download starts, the ADC will display Prog. The Windows
programme will say Erasing Flash (10 secs), then Flash Erased (quick) then
Programming Flash. At this stage a progress bar with a count down time is
displayed, showing how much time is left (30 mins or so). After this has counted
down, the PC says Done and the ADC reboots itself. Depending on the nature
of the software update, it unit may then need to re-initialise its internals – if it
does it will say Hold on its front panel. Do not do anything at this stage. Then,
when that message disappears, it will be back to normal use.