Filter
Top Products
About Your System 17
Diskette drive
n
seek
failure
Incorrect configuration settings in
the System Setup program.
Run the System Setup program to
correct the settings. See "Using the
System Setup Program" on page 23.
Faulty or improperly installed
diskette drive.
Replace the diskette. If the problem
persists, see "Troubleshooting a USB
Device" on page 71.
Loose diskette drive interface cable. Reconnect the diskette drive USB
cable. See "Troubleshooting a USB
Device" on page 71.
Diskette read failure Faulty or improperly inserted
diskette.
Replace the diskette. If the problem
persists, see "Troubleshooting a USB
Device" on page 71.
Diskette subsystem reset
failed
Faulty or improperly installed
diskette.
Replace the diskette. If the problem
persists, see "Troubleshooting a USB
Device" on page 71.
Drive not ready Diskette missing from or improperly
inserted in diskette drive.
Replace the diskette. If the problem
persists, see "Troubleshooting a USB
Device" on page 71.
Error: Incorrect memory
configuration.
CPU
n
System Halted!
Invalid memory configuration. Ensure that the memory modules are
installed in a valid configuration. See
"Memory Module Installation
Guidelines" on page 46. If the problem
persists, see "Troubleshooting System
Memory" on page 76.
Error: Memory failure
detected. Memory size
reduced. Replace the
faulty DIMM as soon as
possible.
Faulty or improperly seated memory
module(s).
See "Troubleshooting System Memory"
on page 76.
Remote configuration
update attempt failed
System unable to process Remote
Configuration request.
Retry Remote Configuration.
Fatal error caused a
system reset: Please
check the system event
log for details.
Fatal system error. Check the system event log for the
specific cause, then see the appropriate
section in"Troubleshooting Your
System" on page 67.
Gate A20 failure Faulty keyboard controller; faulty
system board.
See "Getting Help" on page 95.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions