Filter
Top Products
Installing System Components 37
The system provides space for one optional slimline optical drive. For more information, see "Installing
the Optical Drive in the System" on page 54.
The hard-drive bays provide space for one or two 3.5-inch hard drives. The hard drives connect to the
SATA controller or the system board, or an optional SAS controller card. For more information, see "Hard
Drives" on page 55.
During an installation or troubleshooting procedure, you may be required to change a jumper setting.
For more information, see "Jumpers and Connectors" on page 89.
NOTE: There are no hot-pluggable components inside this system.
Removing and Replacing the Front Bezel
The system front panel is enclosed by an optional bezel. To access the optional optical drive, you must
remove the bezel.
NOTE: You do not need to remove the front bezel to remove the system cover and access internal components.
1
Using the system key, unlock the bezel.
2
Press the tab at the left end of the bezel.
3
Rotate the left end of the bezel away from the system to release the right end of the bezel.
4
Pull the bezel away from the system. See Figure 3-2.
Figure 3-2. Removing the Bezel
To replace the front bezel, perform the preceding steps in reverse.
1 key lock 2 bezel
1
2