Dynex DX-19LD150A11 Flat Panel Television User Manual


 
10
Making connectionsDX-19LD150A11
Using coaxial cable (good)
To connect a cable or satellite box using coaxial cable:
1 Turn off your TV/DVD combo and all connected
equipment.
2 Connect the incoming cable from the cable wall jack
to the cable-in jack on the cable or satellite box.
3 Connect a coaxial cable (not provided) to the
ANT/CABLE IN jack on the back of your TV/DVD
combo and to the coaxial out jack on the cable or
satellite box.
4 Turn on your TV/DVD combo, then turn on the cable
or satellite box.
5 Go through the setup wizard described on page 16.
Connecting an antenna or cable TV (no
box)
To connect an antenna or cable TV (no box):
1 Turn off your TV/DVD combo and all connected
equipment.
2 Connect a coaxial cable to the ANT/CABLE IN jack
on the back of your TV/DVD combo and to the
antenna or cable TV wall jack.
3 Turn on your TV/DVD combo, then go through the
setup wizard described on page 16.
Notes
Use a coaxial cable to eliminate interference
and noise from radio waves.
Do not bundle the coaxial cable with the power
cord or other cables.
P
B
P
R
Cable or satellite box
Back of TV/DVD combo
Coaxial cable
From cable TV
wall jack (75 ohm)
To Cable-in jack on the
cable TV or satellite box
Notes
Use a coaxial cable to eliminate interference
and noise from radio waves.
Do not bundle the coaxial cable with the power
cord or other cables.
If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
P
B
P
R
Back of TV/DVD combo
Coaxial cable
DX-19LD150A11_11-0915_MAN_ENG_V4.book Page 10 Monday, August 29, 2011 8:29 AM