Filter
Top Products
Making connections
9
DX-32E250A12
Using component video (better)
To connect a cable or satellite box using component video:
1 Turn off your TV and all connected equipment.
2 Connect the incoming cable from the cable wall jack to the
cable-in jack on the cable box.
3 Connect a component video cable (not included) to the Y, P
B, and
P
R jacks on the side of your TV and the component video out
jacks on the cable or satellite box.
4 Connect an audio cable (not included) to the L and R audio jacks
on the side of your TV and to the audio out jack on the cable or
satellite TV box.
5 Turn on your TV, then turn on the cable or satellite box.
6 Go through the setup wizard on page 18.
Using composite video (good)
To connect a cable or satellite box using composite video:
1 Turn off your TV and all connected equipment.
2 Connect the incoming cable from the cable wall jack to the
cable-in jack on the cable box.
3 Connect a composite cable (included) to the Y/VIDEO, L, and R
jacks on the side of your TV and to the composite video and audio
out jacks on the cable or satellite box.
4 Turn on your TV, then turn on the cable or satellite box.
5 Go through the setup wizard on page 18.
Note
When you connect the audio using the L and R audio
jacks, the audio output is analog.
If your TV has a digital audio jack (optical or coaxial),
you can connect the video to the component video
jacks and connect the audio to the digital audio jack
to get digital audio output.
Side of TV
Component video cable
Audio cable
Cable or satellite box
Side of TV
Cable or satellite box
A/V cable
The audio cables are color coded
(white and red) to the L and R
audio jacks.
The video cable (yellow) shares a
jack with the component Y cable
and goes to the green jack.
DX-32E250A12_11-0610_V1.book Page 9 Monday, September 26, 2011 7:58 AM