Filter
Top Products
21
Motion Detection Setup
Mask Type
3 Options (4x3, 8x6, 16x12). Select the size of the mask that will be used to configure the
motion detection area in the view window. Default value is 16x12.
Mask Select
3 Options (Select All, Clear ALL, User define). Select the initial masked area.
Sensitivity
3 Options (High, Mid, Low). Default value is Middle sensitivity.
Detection Area Setting
Move the focus to the picture area. Use
“Enter” button to toggle on/off the grid.
Press “Exit” button to leave the picture
grids area.
Motion Act (action)
Maximum 4 options. Define the corresponding Motion Action while motion detection is
enabled. .Default value is “MotionA01”. Move the focus to the Config icon will be enabled
for user to configure the motion action behavior. Move the focus to the icon and press “Enter”
button to show the Motion Action Dialog as Figure 1:
->
Action Tag
Move the focus to “Edit” icon and press “Enter” button to edit action tag if necessary. Simulated
keyboard will pop up once user starts the edit function (Figure 2) to edit the Action Tag (total 10
characters available). Move to “OK” icon after finished editing and press “Enter” button to confirm
editing. Press “Exit” button to return to previous dialog
Pre-Recording
Define the pre-recording time (0~10 seconds) for corresponding camera. Default value is 5 Sec.
Figure 1 Figure 2