Filter
Top Products
VR101S
Users Manual
8
Installing EventView software
1. Before installing EventView software, close other
applications, or restart Windows.
2. For Windows 3.1, open Program Manager, select
File from the menu bar and choose Run...
Windows 95/98/NT users select Start from the
Taskbar on the desktop and choose Run...
3. Insert EventView Disk 1 of 2 in your computer’s
disk drive. In the Run dialog box, type a:setup for
drive A and press Enter (the Return key on some
keyboards). If you are using drive B, type b:setup.
4. EventView supports several languages. If one of
these languages has been specified in the
Windows control panel, EventView uses the same
language. If any other language is specified in
Windows, the EventView setup procedure displays
a language selection menu. Select the desired
language.
During the following steps, change diskette as
indicated.
5. A
“Welcome!”
dialog box will appear asking you to
click Next if you want to start installing the
EventView Software on your hard drive.
6. An information screen appears to inform you about
some important items for installation and use of
EventView Software. Read this carefully. Click
Next.
7. Select the Destination Directory for the EventView
Software. If you want to install the software in the
default directory, click Next. If you prefer another
directory, click Browse to select this directory, then
click Next.
8. A dialog box appears asking if you would like to
back up replaced files. It is a good idea to do so
(select “Yes”.) Click Next.