Filter
Top Products
Setting Up the VR101
Starting EventView
2
15
Viewing the Default Threshold Settings
The EventView program has factory-installed default
threshold settings. These settings are adequate for
most applications.
• To see the default threshold settings on the Status
tab, click the Default Setup button.
If you are concerned that some of your electronic
equipment may have particular power quality
requirements, we suggest that you call the equipment
manufacturer for that information. You may discover
that you should alter some of the recorder’s threshold
settings in order to monitor power quality more closely.
Choosing and Saving New Default Threshold
Settings
If the factory-installed default threshold settings of the
recorder do not suit your application you may choose
new settings and designate them as the default settings.
1. Make your changes to the settings.
2. Click the Save as Default Setup button.
3. In the dialog box that appears, click OK to confirm
that the default settings will be changed.
These settings are now saved in your computer and
can be sent to any recorder that you communicate
with by clicking Send Setup/Clear Recorder.
Choosing Operating Options
Stop Recording When Full or Overwrite Oldest
Events When Full
A recorder can store 4,000 events. You can program it
to either stop recording events or to continue recording
when it is full and record over the oldest events in its
memory.
• Choose either Stop Recording When Full or
Overwrite Oldest Events When Full.
Flash When Data Available
• Check Flash When Data Available if you want the
recorder to blink when it has stored one or more
events (default condition).