Filter
Top Products
104
Warning:
To avoid electrical shock or equipment malfunction do not
attempt to make electrical ground connections by yourself.
Contact the appropriate inspection authority or an electrician,
as appropriate.
Unintentional emitter per ICES-003
This digital apparatus does not exceed the Class B
limits for radio noise emissions from digital apparatus as
set out in the radio interference regulations of Industry
Canada.
Le présent appareil numérique n’émet pas de bruits
radioélectriques dépassant les limites applicables aux
appareils numériques de Classe B prescrites dans le
règlement sur le brouillage radioélectrique édicté par
Industrie Canada.
Telecommunications per Industry Canada CS-03
(for products fitted with an IC-compliant modem)
The Industry Canada label identifies certified equipment.
This certification means that the equipment meets
certain telecommunications network protective,
operation, and safety requirements. The Department
does not guarantee the equipment will operate to the
users’ satisfaction.
Before installing this equipment, users should make sure
that it is permissible to be connected to the facilities of
the local telecommunications company. The equipment
must also be installed using an acceptable method of
connection. In some cases, the inside wiring associated
with a single-line individual service may be extended by
means of a certified connector assembly. The customer
should be aware that compliance with the above
conditions may not prevent degradation of service in
some situations.
Repairs to certified equipment should be made by an
authorized Canadian maintenance facility designated by
the supplier. Any repairs or alterations made by the user
to this equipment, or equipment malfunctions, may give
the telecommunications company cause to request the
user to disconnect the equipment.
Users should make sure, for their own protection, that
the electrical ground connections of the power utility,
telephone lines, and internal metallic water pipe system,
if present, are connected together. This precaution may
be particularly important in rural areas.
The Ringer Equivalence Number (REN) assigned
to each terminal device provides an indication of the
maximum number of terminals allowed to be connected
to a telephone interface. The termination on an interface
may consist of any combination of devices subject
only to the requirement that the sum of the Ringer
Equivalence Numbers of all the devices does not
exceed 5.
Mexico
Unintentional emitter
At this time there are no mandatory requirements for
Unintentional Emitters. However, this device does comply
with multiple requirements for other countries and
regions as listed on the system label and in the user’s
manual.