Filter
Top Products
Automatically Copying Files to CD 9-5
Chapter 9: Find Files Fast
with HP Simple Trax
5. Simple Trax will then prompt you to type a name to identify the CD. This
name is used in the HP Simple Trax Index for identification. Be sure to
write the same name on the CD label with a felt-tip pen.
Using the Wizard to Set a Schedule
The Wizard is the easiest way to set up a Simple Trax schedule. If you
want more control over how you set up the schedule, you might want to
review the section, “Using the Control Panel to Set up a Schedule” on
page 9-6.
To use the Wizard:
1. Click the Start button and point to Programs, then to HP CD-Writer
Plus, then to HP Simple Trax, and click HP Simple Trax Control Panel.
The Control Panel appears:
2. Click on the Run Wizard instead button near the bottom of the Control
Panel.
3. Follow the instructions on the screen.
Before an Automatic Operation will Run
If you plan to use a new CD for the automatic operation, be sure to read
the section, “Preparing a CD for Automatic Operations” on page 9-4. It
will teach you how to format and name the CD. If a prepared CD is not
inserted, the scheduled operation will not begin.
Click to
start the
Wizard.