Filter
Top Products
DELAYED RECORDING
Note: If program is overlap, the VCR gives you an error message that disappears from the screen in about 5
seconds.
13 Press the POWER button to turn off the VCR. The delayed recording indicator will display on
the VCR.
This tells you that the VCR will automatically record at the times and dates you have programmed.
Note: If a cassette has not been inserted or a cassette without safety tab has been inserted, the delayed
recording indicator will flash to warn you. The cassette without safety tab will be ejected automatically. Be
sure to insert a cassette with safety tab intact.
The VCR will automatically give a warning display on the screen 5 minutes before timer recording is to
start .
When you have set up all the timed recordings you want:
Don't forget to load a videocassette (with the safety tab still attached) to record on.
If you have installed a cable box (see page 23), turn on the cable box and select the channel you
want to record on the cable box (08 in this case) before recording starts.
To stop recording while in the timed recording mode:
1 Press the POWER button.
2 Press the STOP button within 10 seconds.
This can be done either on the VCR or with the remote control.
Important: Your timed recording settings take effect when you turn off the power on the VCR.