Filter
Top Products
EASY DELAYED RECORDING WITH THE VCR PLUS+ SYSTEM
The delayed recording indicator will display on the VCR.
This tells you that the VCR will automatically record at the times and dates you have programmed.
Note: If a cassette has not been inserted or a cassette without safety tab has been inserted, the delayed
recording indicator will flash to warn you. The cassette without safety tab will be ejected automatically. Be
sure to insert a cassette with safety tab intact.
The VCR will automatically give a warning display on the screen 5 minutes before timer recording is to
start.
When you have set up all the timed recordings you want:
Don't forget to load a videocassette (With the safety tab still attached) to record on.
If you have installed a cable box (see page 23), turn on the cable box and select the channel
you want to record on the cable box before recording starts.
Important: Your timed recording settings take effect when you turn off the power on the VCR.
Caution of VCR Plus+ Recording
After entering a PlusCode number, check the information displayed with the "PROGRAM REVIEW". If
there is (are) any unnecessary program (s), please cancel or correct it (them). Please refer to page 49,
"Reviewing what you have programmed".
Using the VCR Plus+ system to record a program (by using VCR's
display)
You can use the VCR Plus+ system to program the timer, observing the VCR's display, without turning on
the power to the VCR and TV.
Notes:
If you use the VCR Plus+ system to program the timer while observing the VCR's display, you can only
program a one-time recording.
To stop programming, press the POWER button to turn the VCR power on.
1 Insert a blank or erasable tape.
The power comes on automatically and the tape indicator lights on the display.
When a cassette without its safety tab is inserted, playback starts automatically and VCR Plus+
recording won't operate.
Power
2 Press the POWER button to turn off the VCR.
3 Press the PROG./VCR+ button.
The clock display switches to the indication shown on the right.
If eight programs have already been stored in memory, "FULL" will flash in the VCR's display for
about five seconds.