Filter
Top Products
Administrator’s Guide and Operating Instructions
25
Alarm Out – To define which Alarm Output will be triggered when
the hard disk capacity is full. NC and NO signals are available,
please refer to Alarm Out Setup. Click on the Down arrow button
to select one of the Alarm Outputs (AO 1-8).
Output – Alarm Out output state when the hard disk capacity is full.
For NC signal, it’s always open, for NO signal close. The Normal
State above shows whether the selected Alarm Out is NC signal or
NO signal.
Buzzer On – To activate the internal buzzer or not when the full hard
disk capacity is detected.
Log – Log to event log list or not. Please refer to Log Display for
the details.
Note. If the hard disk capacity reaches the end with the Auto Overwrite function not
enabled while the user login in as an Operator, the system will show a message
to ask the user to login in as an Administrator or Supervisor for the further
procedures.